Skip to content

Tanking and waterproofing.

Tanking is waterproofing for rooms below ground, where the walls hold back wet soil all year rather than the odd shower of rain. The British Standard, BS 8102:2022, sets out three ways to do it: a barrier coating on the wall (Type A), a structure that keeps water out by itself (Type B), or a drained membrane that collects the water and pumps it away (Type C). Choosing the wrong one is a common reason basement conversions fail.

A dry, finished basement room with a sofa, a rug and a window at ground level

Signs to look for

  • Standing water or a tide mark on a cellar floor
  • White salts crusting on the brickwork below ground
  • A cellar that smells musty however much you air it
  • Water that appears after days of rain rather than during it
  • Old tanking plaster that has bulged or come away from the wall

Why basements are different

A wall above ground deals with rain that comes and goes. A basement wall holds back wet ground that presses against it all the time. Water under pressure finds any weak spot, and a coating that works well on a garden wall will be pushed off a cellar wall.

Parts of Sussex make this harder. Groundwater in the chalk under the Downs rises and falls with the seasons, and homes on the flat land around Shoreham, Lancing and Worthing can sit close to the water table. That's how a cellar can stay dry for years and then flood in one wet winter.

Choosing the right system

Type A is a waterproof cement coating, often called tanking slurry, applied straight onto the wall. It suits sound brickwork under modest pressure, and it's the cheaper option. But it depends entirely on the wall staying sound, and it can't cope with movement.

Type C uses a studded plastic membrane fixed to the wall. It accepts that water will get in and manages it rather than trying to hold it back. Water runs down behind the membrane into a channel around the edge of the floor, then to a sump, where a pump takes it away. It copes better with movement, it can be maintained, and it's what we recommend for basements people will live in.

The catch is that Type C needs a pump, and a pump needs power. Any Type C system in a room you live in should have a battery backup and a high-water alarm, because storms are when the power is most likely to go off and when the pump is needed most.

Design and guarantees

BS 8102:2022 recommends that the waterproofing is designed by a suitably qualified specialist, and that more than one type of protection is considered for rooms people live in. If a basement is being converted into living space, building control will usually want to see that design, and the recognised qualification for it is the CSSW (Certificated Surveyor in Structural Waterproofing). If your project needs that level of design, we'll tell you rather than guess.

Insurance-backed guarantees matter more here than anywhere else in damp work, because putting right a failed basement system is disruptive and expensive. We'll be clear about what's covered and what isn't.

Common questions

Can I tank a cellar myself?

You can apply a slurry yourself, and for a storage cellar with a minor problem that may be enough. For a room you plan to live in, the waterproofing needs designing to BS 8102 and usually has to satisfy building control, which isn't a DIY job.

Does a sump pump run all the time?

No. It runs when the sump fills, which in most homes is now and then, and mostly in winter. The pump should be sized for the worst case rather than the average, with a backup, because if it fails, the room floods.

Will tanking add value to my home?

A properly designed and documented system that turns an unusable cellar into living space generally adds value. Waterproofing of an unknown type, with no paperwork, tends to raise questions when you sell, so keep the specification and the guarantee.

Call 07365 672153 Book a free check